Rockwell Kepserver Drivers For Schneider

Rockwell Kepserver Drivers For Schneider

Communication is managed through a robust platform that supports a collection of standards drivers for Schneider Electric, Siemens, Rockwell, Mitsubishi, Wago.

Please check documentations (release notes, readme) available on the KB.

I have searched the Kepserver site, and the Rockwell site, with no specific answers.(Oh yeah, and this site) RSEmulate 5K seems to function fine, I can download, monitor etc in Program mode and Run mode flawlessly.

I see dynamic data.

The problem arises when I attempt to setup the new device in Kepserver.

This is the process I have gone through in order to setup the communication interface with Kepserver.

After selecting a New Device, I add a Contrologix 5500, which seems to be the only logical choice for my application.

Virtual Backplane Emulator listed) I enter in my local PC IP address (192.168.1.10,1,2),1,2(Slot of processor is 2 based on RsEmulate and RSL5K project settings) The tags at this point should auto-generate (based on the Kepserver documentation).but nothing seems to happen.

If you have recently purchased your KepserverEX, you have 90 days of tech support.

If it was going to connect over Ethernet to a remote computer, it would need an EtherNetIP module.

You can create those in the Virtual Backplane with SoftLogix 5000, but not with RSEmulate 5000.

You might still be able to get Kepware to access RSEmulate 500 by bridging through RSLinx Classic Gateway or RSLinx Enterprise, but thats outside my experience (and ability to set up right now).